Motorola LM100 Provozní pokyny stáhnout pdf (Strana 44)

Operation 4-9

GX2-LM1000E* Installation and Operation Manual

Parameter Status LED

+12 V current-major high alarm

Red

Module temperature-major low alarm

Red

Module temperature-minor low alarm

Yellow

Module temperature-minor high alarm

Yellow

Module temperature-major high alarm

Red

Factory data NVM CRC-minor alarm

Yellow

Laser Data NVM CRC-major alarm

Red

Alarm Limit NVM CRC-major alarm

Red

Boot status-major alarm

Red

Flash status-major alarm

Red

Hardware-major alarm

Red

Operating the GX2-LM1000E* with the Optional SDU

You can control and operate the GX2-LM1000E* using the optional SDU with display. This

includes selecting any of the previously referenced control modes and the ability to monitor the

numerous parameters and alarm conditions within the GX2-LM1000E*.

Appendix B, “Menus” provides the GX2-LM1000E* SDU menu structure and information on

how to use the optional SDU with display.

Downloading New Firmware

The GX2-LM1000E* can store up to two sets of firmware programs, which you can download

through the network management system. When the download is complete, the GX2-LM1000E*

uses the new firmware for each subsequent boot up. The operator also has the option of selecting

and using any stored set of firmware code at each boot up.

The network management system enables the operator to view the following information about

the firmware programs stored in the GX2-LM1000E*:

 Firmware revision level

 Firmware code CRC

 Which set of firmware will run at the next boot up

The operator has the option of selecting a specific module or all modules of the target type for

download. After all options are selected, the operator can initiate the download.

To download firmware, the network management system must be running and communicating

with the GX2-CM100B. The GX2-CM100B and the network management system perform the

following tasks to download the new firmware:

 The network management system reads the firmware download file selected by the operator

and verifies the program code CRC. The software reads the target module type and

firmware revision to be downloaded from the file and displays this information for operator

verification.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 60 61

Komentáře k této Příručce

Žádné komentáře

Motorola LM100 Provozní pokyny Strana 44

Komentáře k této Příručce

Související produkty a manuály pro Elektronika motorových vozidel Motorola LM100