Motorola MVME2700 Series Servisní příručka stáhnout pdf (Strana 69)

Hardware Installation

http://www.motorola.com/computer/literature 1-49

PMC Module Installation

PCI mezzanine card (PMC) modules mount beside the RAM200

mezzanine on top of the MVME2700 base board. To install a PMC

module, refer to Figure 1-21 and proceed as follows:

1. Attach an ESD strap to your wrist. Attach the other end of the ESD

strap to the chassis as a ground. The ESD strap must be secured to

your wrist and to ground throughout the procedure.

2. Perform an operating system shutdown. Turn the AC or DC power

off and remove the AC cord or DC power lines from the system.

Remove chassis or system cover(s) as necessary for access to the

VME modules.

Caution

Inserting or removing modules with power applied may result in damage

to module components.

Warning

Dangerous voltages, capable of causing death, are present in this

equipment. Use extreme caution when handling, testing, and adjusting.

3. Carefully remove the MVME2700 from its VMEbus card slot and

lay it flat, with connectors P1 and P2 facing you.

Caution

Avoid touching areas of integrated circuitry; static discharge can damage

these circuits.

4. Remove the PCI filler from the front panel.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 214 215

Žádné komentáře

Motorola MVME2700 Series Servisní příručka Strana 69