Motorola LD-W-1 Specifikace stáhnout pdf (Strana 12)

English Locomotive decoders 30s series

Page 12

KI: The integral component of the load control ensures the remaining

difference between the set and the present value is reduced to 0 and so

for the correction of very small divergences. If the set value is too high

the locomotive vibrates massively while moving.

KD: The differential component of the load control ensures that the control

is not converted too quickly. Is the set value to low then the locomotive

vibrates. If the set value is too high, the locomotive shakes while moving.

Velocity characteristic

The decoders can be adjusted to the driving characteristics of the

motor and the characteristic speed of the locomotive type, by setting the

starting velocity and the maximum velocity. From the starting velocity and

the maximum velocity the decoder generates a linear velocity characteristic.

When the speed level mode is set to 28 speed levels, it is possible to

assign any motor voltage to all of the 28 speed levels as an alternative

to the linear velocity characteristic. This allows the programming of a

velocity characteristic which adjusts the individual driving characteristics

of the motor. The set values are saved in the alternative velocity table.

Shunting gear

It is possible to switch into the shunting gear mode via a function key,

when so programmed. In the shunting gear mode, the velocity of all

speed levels is reduced to approx. 50 % compared to the set velocity.

Acceleration and brake delay

It is possible to program the acceleration and brake delay individually

via the central unit. When so programmed, it can be switched on and off

with the function key F3.

Emergency stop

It is possible to carry out an emergeny stop at a change of direction

automatically, when so programmed.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Žádné komentáře

Motorola LD-W-1 Specifikace Strana 12