5
CPX8216 and CPX8216T Installation and Use (6806800A52C)
33
5 Chassis Installation
Overview
This chapter discusses the installation options for the CPX8000 Series Platforms. The following
topics are discussed in this chapter.
■ Tools You Will Need
■ Mounting Hole Locations
■ Mounting Dimension for a 19" Frame Relay or EIA Rack
■ Mounting Dimension for a 23" Frame Relay or EIA Rack
■ Installing the Chassis in a Frame Relay Rack/Cabinet
■ Installing the Chassis in an EIA Equipment Rack/Cabinet
■ Connecting the Chassis Cables
Tools You Will Need
You will need the following tools to complete the installation:
■ Torque wrench
■ Phillips head screwdriver #1
■ Phillips head screwdriver #2
Electrostatic Discharge (ESD) and Safety Procedures
ESD
Emerson strongly recommends that you use an antistatic wrist strap and a conductive
foam pad when installing or upgrading a chassis. Electronic components, such as disk
drives, computer boards, and memory modules, can be extremely sensitive to
electrostatic discharge (ESD). After removing the component from its protective
wrapper or from the chassis, place the component flat on a grounded, static-free
surface (and, in the case of a board, component side up). Do not slide the component
over any surface.
If an ESD station is not available, you can avoid damage resulting from ESD by wearing
an antistatic wrist strap (available at electronics stores) that is attached to an active
electrical ground. Note that a chassis may not be grounded if it is unplugged.
Komentáře k této Příručce