Motorola MC21XX SERIES Uživatelská příručka stáhnout pdf (Strana 23)

Getting Started 1 - 7

1. Remove the mini stylus from the back of the MC21XX.

2. Carefully press and briefly hold the stylus tip on the center of the Calibration screen target. Repeat the

procedure as the target moves and stops at different locations on the screen. This enters the new

calibration settings.

Figure 1-6

Calibration Screen

3. Once all of the new calibration settings are input, tap the screen or press the ENTER button to save the

new calibration settings. Press ESC to discard the new calibration settings.

Main Battery Removal

To remove the main battery from an MC21XX:

1. If the MC21XX is in suspend mode, press the Power button to wake the MC21XX.

2. Press the Power button to place the MC21XX in suspend mode.

3. On the MC2180, tap Safe Battery Swap.

On the MC2100, using the navigation pad, scroll down to Safe Battery Swap. Press the Enter key.

4. Wait for the LED Indicator to turn red and then turn off.

5. Using thumbs, push the two battery latches up. The battery ejects slightly.

CAUTION When removing the battery, follow the Safe Battery Swap procedures below otherwise loss of data or

system corruption may occur.

When in Safe Battery Swap mode, the MC21XX goes into a low power suspend state. All wakeup are

disabled.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 115 116

Žádné komentáře

Motorola MC21XX SERIES Uživatelská příručka Strana 23